|
|
How to make a Rope Harness Ok, this first time takes longer than 7 minutes, but after you have it made, it gets faster and faster. Materials:
Take the rope and stretch it out, evenly loop it through the D ring on the collar. Either pull it through it's self, or tie it in place. Tape or melt the ends of the rope. Get nekkid! Well really it's the only way for a good fit. *grin* put on the collar and adjust it so that it isn't very tight, if there is slack left over when you are done, you can re-adjust it. Soo, there you are, nekkid with a dog collar trailing two equal very long lengths of rope. Hang on, let me go get a camera. *grin* Stand in front of a mirror and as you look down at your body and up in the mirror... Eye gauge and put a knot on both ropes *above* your breasts, just *below* the breasts, about 2 inches above the belly button and about 2 inches under it. One knot above the mounds, one over the clit. ( Or penis ) Now you have a rope with 7 knots in it. Those stay, this is the base for your Diamond harness. What you've just done is the most time consuming part of the process. After you do the wrapping a few times and " get it " it will go fast and smooth. Take the ends and pass them between your legs, bring them around where your thighs join your body. Now you have a rope in each hand that you put through the lowest knot. Standing, you have the knotted front, with a rope coming low around each hip, threaded through the lowest knot and hanging. Take the ropes, one in each hand and pass them around your body. Do NOT pass the ropes totally around you, pass them over each other, then bring each one back the way it came. Pass the ropes through the next tied off section in the front, wrap again, snug it up. Do this all the way up to the collar, you can tie it off to the D ring. Look at the effect in the mirror and grin. Have fun! |
