|
Modified Solomon Bar Rope Cuffs (Race Bannon Style)
by Rope Fashions
These wrist and ankle cuffs have the feel of rope, but the
convenience of leather restraints. They are based on a knot
called a Solomon bar. I first learned about Solomon bar cuffs
from a brochure published by Race Bannon, of San Francisco.
The cuffs shown here are a variation on the original design.
Instead of using one 11-foot rope and one five-foot rope
per cuff, this design makes each cuff out of a single 20-foot
length of rope.
They are just the thing for when you are out of town
and you realize you forgot your cuffs. Just go down to
the hardware store and buy 80 feet of rope, and some
electrical tape for the ends, and in half an hour you
can make yourself a set of cuffs.
|
Step 1:
We begin by taking a 20-foot length of rope and doubling it.
We are using 5/16-inch rope; you don't want to use too large a
diameter.
|
Step 2:
About three feet from the doubled end of the rope, cross one
end of the rope over the other, to begin a square knot.
|
Step 3:
Take the end underneath the rope it just went over, so the two
ropes are twisted together.
|
Step 4:
Now repeat the last two steps, starting with the opposite side,
to make a square knot.
|
Step 5:
When you tighten the knot, pull the two ropes on each side
together, as shown by the arrows. Otherwise, the knot will slide
along the ropes.
|
Step 6:
Now take the doubled end of the rope, fold it over on itself,
and push the end through the middle of the square knot
you just made, leaving a little loop sticking through.
|
Step 7:
Pull the square knot tight, again making sure to pull the two
ropes on each side together, to keep the knot from sliding.
|
Step 8:
You should now have two large loops below the knot, and one
small loop above the knot. Gather the large loops together,
so that all the ropes are parallel.
|
Step 9:
You should have two ropes sticking out to the sides. Take the
right-hand one and cross it over to the left, crossing over
the loops you just gathered up.
|
Step 10:
Now take the left hand rope and cross it over to the right, going
over the rope from the previous step, as well as the gathered loop
ropes.
|
Step 11:
Take the end of the rope under the rope that you crossed from
right to left two steps ago. Bring it out through the loop and
pull it tight.
|
Step 12:
You have just tied a square knot around the gathered loop ropes.
To make the next knot, take the left-hand rope (the opposite
one from what you started with on the previous knot) and
cross it over the gathered loop ropes, from left to right.
|
Step 13:
Take the right-hand rope, cross it over the rope from the previous
step, then cross it under the gathered loop ropes.
|
Step 14:
Take the end of the rope up through the loop from two steps back,
and pull the knot snug. This completes your second square knot.
|
Step 15:
Now take the right-hand rope and cross it over the gathered loop
ropes, just like you did for the first square knot.
|
Step 16:
Continue this process of making square knots, alternating between
starting on the left and starting on the right. If you get confused
as to where you are, look at the pattern that the ropes make. One
will seem to be zig-zagging on the top and one will be doing the
same on the bottom. If you look at the pattern you can easily
see if you have forgotten to alternate the sides.
Keep making square knots until the you have almost enough
to go around the wrist or ankle.
|
Step 17:
Lay the wrist or ankle on top of the cuff. Notice that you have
a small loop on one end, and two larger loops on the other.
|
Step 18:
Now make a square knot with the two loops. Left over right...
|
Step 19:
and right over left.
|
Step 20:
If the cuff is too loose, untie the loops, then remove one or
two square knots from the body of the cuff. If it is too
tight, add one or two square knots. One of the beauties of this
cuff is that it is completely adjustable.
|
Step 21:
Take the ends of the ropes, and run them through the two loops.
This will keep your captive from untying the cuff.
|
Step 22:
Here is the final result. I hope you enjoy using it as much as I do.
TyingItAllTogether has a video on YouTube that demonstrates how
to tie a decorative, non-kinky, Solomon bar. You might take a
look at it to see the how the basic knots are tied.
|
