|
Single Wrap Rope Bit Gag
by Rope Fashions
This is an attractive, quick-to-make bit gag. The rope has
a lot more give than rubber bit gags, so you won't get the jaw
strain that you can get when you spend a whole scene chomping
down on a rubberbit.
This gag can be a handy way to deal with a mouthy sub.
When your sub is mouthy, you can grab a piece of rope and
start making up the gag. She should get the message.
If she doesn't by the time you're finished, in goes the
gag.
|
Step 1:
The gag begins with a length of 5/16-inch rope. We use a 12-foot
piece, because that's one of our standard lengths,
but anything over 6 feet in length will probably do.
Double the rope, but do not match up the ends. Instead,
measure about seven hand-widths up one end of the rope,
and match the other end to that point. This will make
the ends come out even when you are finished. (You may have to
adjust things slightly, based on the width of your hand.)
|
Step 2:
About one hand-width from the end of the loop, start wrapping the
long end of the rope around both strands of the loop, heading
back towards the loop.
|
Step 3:
Continue wrapping.
|
Step 4:
When you have wrapped almost all the way to the end of the loop,
so that the loop is just big enough to stick a strand of rope
through, stick the long end of the rope through the loop.
|
Step 5:
Pull it tight.
|
Step 6:
Gently tug alternately on the two ends until the bit snugs up
and is solid.
|
Step 7:
Here is how the gag looks in use. If you would like a bulkier gag,
you can try the double-wrap rope bit gag, which is described in
another tutorial.
|
